10/30/2022 0 Comments Packet Tracer 6.4.3.4![]() ![]() R3(config-if)# ipv6 eigrp 1 Part 2: Verify EIGRP for IPv6 Routing Step 1: Examine neighbor adjacencies. R3(config-rtr)# eigrp router-id 3.3.3.3 Step 4: Using AS 1, configure EIGRP for IPv6 on each interface. R3(config-rtr)# no shutdown Step 3: Assign a router ID to each router. ![]() Issue a command that will enable EIGRP for IPv6 routing in R1, R2 and R3.Įnable the EIGRP process on all routers and use 1 as the Autonomous System number. ![]() The IPv6 routing process is shutdown by default. R3(config)# ipv6 unicast-routing Step 2: Enable EIGRP for IPv6 routing on each router. Part 1: Configure EIGRP for IPv6 Routing Step 1: Enable IPv6 routing on each router. The EIGRP for IPv6 routing process uses a “shutdown” feature. With EIGRP for IPv6, a router-id is required on each router or the routing process will not start. There are a few major differences between them:ĮIGRP for IPv6 is configured directly on the router interfaces. You will also assign router IDs, configure passive interfaces, verify the network is fully converged, and display routing information using show commands.ĮIGRP for IPv6 has the same overall operation and features as EIGRP for IPv4. In this activity, you will configure the network with EIGRP routing for IPv6. Part 2: Verify IPv6 EIGRP for IPv6 Routing Scenario Instructor Note: Red font color or Gray highlights indicate text that appears in the instructor copy only. Packet Tracer – Configuring Basic EIGRP with IPv6 (Instructor Version) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |